PrimaSELECT™ PLA Glossy is a very nice 3D Print material, it's non-toxic and has a no unpleasant smell when you print with it. Because of its thermal characteristics it's easy to get great prints. Filament from PrimaCreator comes on a transparent spool which makes it easy to see how much filament there are left on the spool. PrimaSELECT™ PLA Glossy is a new type of PLA that is much stronger than regular PLA and has a heat resistance up to 75°C. This means that you can use it for mechanical parts, as well as parts that you can use in (for example) a hot car during summer without the risk of the print going soft. PLA Glossy is a unique filament due to it’s shiny surface. It will produce prints with an extremely shiny/metal finish that really stands out. PLA Glossy is used the same way as regular PLA but with a slightly higher temperature range. The print temperature should be between 210 – 230°C (typical is 220°C). The filament should be used with a heated build plate for best results and depending on size of the print you, can use it with a range of 20 – 90°C (typical is 60°C) Use normal print speed 40-60 mm/s. We recommend that you use PrimaFIX on you build surface for best adhesion and to avoid warping. WHY SHOULD I USE PRIMASELECT™ PLA GLOSSY? 750 gr on the spool Very easy to print with Excellent layer adhesion Unique metallic look, very glossy FDA approved Made from 100% virgin PLA pellets Excellent mechanical properties Better heat resistance than normal PLA Se produsentens nettside for mer informasjon. Flere detaljer